BullFrog Spas - Super Sanitation

42
Maintaining Spa Water
Sanitiser and pH Levels
It is important to test and adjust the sanitiser and pH levels of your spa on a
frequent basis. ese tests should be performed prior to each use of the spa.
At a minimum, it is recommended that you test the spa water 2-3 times a
week, regardless of use.
Always test the pH level before you test the sanitiser level. If the pH level is
not within the correct range (7.4-7.6), make the necessary adjustments.
With each sanitiser test, use either granular Chlorine(Dichlor-type only) or
granular Bromine to maintain the following levels:
Without Ozone With Ozone
Chlorine Level 3.0-4.0 PPM 1.0-3.0 PPM
Bromine Level 2.0-4.0 PPM 4.0-10.0 PPM
Hydrogen Peroxide Level 80 ± 100 P PM 60-80 PPM
IMPORTANT: To maintain the level of sanitiser with Bromine or Chlorine
(Dichlor-type only) tablets, contact your authorised Spa dealer for assistance.
Super Sanitation (Spa Shock)
Super Sanitise the water once a week by adding 40 grams (2.5 tablespoons)
of Spa Fresh Shock (or equivalent) per 1000 litres of water
NOTE:Super sanitation may be required more than once per week for heavy
usage.
Stain and Scale Control
Use a Stain and Scale Inhibitor per the manufacturer’s instructions.
Add the chemical 3-4 days after Super Sanitation.
Foam Control
Use a Foam Remover per the manufacturer’s instructions as needed.
Cloudy Water Prevention and Control
Use a Water Clarier per the manufacturer’s instructions.
Add the chemical 3-4 days after Super Sanitation.