BullFrog Spas - TROUBLESHOOTING GUIDE

78
Sensor-Related Messages
Sensor Balance is Poor
e temperature sensors MAY be out of sync by 1°C or 1.5°C. Call for Service.
Sensor Balance is Poor*
e temperature sensors ARE out of sync. e Sensor Balance is Poor fault has been established for at least 1 hour. Call for Service.
Sensor Failure – Sensor A, Sensor B
A temperature sensor or sensor circuit has failed. Call for Service.
Sensor-Related Messages
Miscellaneous Messages
READY
RANGE
FLTR 1
Sensor Balance is Poor
The temperature sensors MAY be out of sync by 2°F or 3°F. Call for Service.
Sensor Balance is Poor*
The temperature sensors ARE out of sync. The Sensor Balance is Poor fault has been established for at least 1 hour.
Call for Service.
Sensor Failure – Sensor A, Sensor B
A temperature sensor or sensor circuit has failed. Call for Service.
READY
RANGE
FLTR 1
No Communications
The control panel is not receiving communication from the System. Call for Service.
Pre-Production Software
The Control System is operating with test software. Call for Service.
°F or °C is replaced by °T
The Control System is in Test Mode. Call for Service.
* This message can be reset from the topside panel with any button press.
Sensor-Related Messages
Miscellaneous Messages
READY
RANGE
FLTR 1
Sensor Balance is Poor
The temperature sensors MAY be out of sync by 2°F or 3°F. Call for Service.
Sensor Balance is Poor*
The temperature sensors ARE out of sync. The Sensor Balance is Poor fault has been established for at least 1 hour.
Call for Service.
Sensor Failure – Sensor A, Sensor B
A temperature sensor or sensor circuit has failed. Call for Service.
READY
RANGE
FLTR 1
No Communications
The control panel is not receiving communication from the System. Call for Service.
Pre-Production Software
The Control System is operating with test software. Call for Service.
°F or °C is replaced by °T
The Control System is in Test Mode. Call for Service.
* This message can be reset from the topside panel with any button press.
Sensor-Related Messages
Miscellaneous Messages
READY
RANGE
FLTR 1
Sensor Balance is Poor
The temperature sensors MAY be out of sync by 2°F or 3°F. Call for Service.
Sensor Balance is Poor*
The temperature sensors ARE out of sync. The Sensor Balance is Poor fault has been established for at least 1 hour.
Call for Service.
Sensor Failure – Sensor A, Sensor B
A temperature sensor or sensor circuit has failed. Call for Service.
READY
RANGE
FLTR 1
No Communications
The control panel is not receiving communication from the System. Call for Service.
Pre-Production Software
The Control System is operating with test software. Call for Service.
°F or °C is replaced by °T
The Control System is in Test Mode. Call for Service.
* This message can be reset from the topside panel with any button press.