51
Step 2: JetPak II A & R series spas. Open all lower valves to allow the water
to drain form each pak as you drain the spa. Once the water is completely out
of the spa then close each jetpak II valve before starting step 3.
Step 3: Use a wet shop vacuum to vacuum the plumbing lines by placing the
vacuum nozzle over each of the lower jet faces in the spa. Lower jets are any
at or below the bench seat area
Step 4: Remove the drain plug from the pump(s), loosen all PVC pipe unions,
and pump air-bleed valves in the equipment compartment. Do not replace
the plugs, tighten the unions or close the air-bleed valves until the spa is de-
winterized.
Step 5: Clean the entire spa.
Step 6: Remove lter cartridge(s) and clean. Do not reinstall until they are
completely dry.
Step 7: Secure the cover to the spa utilizing the tie downs and locking system.
In areas where heavy snow is anticipated, place a large piece of plywood (or its
equivalent) on top of the spa cover to assist in supporting the cover with the
added weight of the snow. Remove snow o the cover following each snow
storm.
WARNING: To avoid water from becoming trapped between the oor
suction tting and the lter pipe . Use a wet/dry vacuum to remove the
remaining water out of pipe by placing the vacuum end over the lter hole.
In a two-pump spa, rst plug o one lter using a tennis ball then vacuum
out the water. Or pour ½-1 gallons (5-9 liters) of RV antifreeze into the
lter hole.
NOTE: RV antifreeze is nontoxic and does not require evacuation at start up.
Spa De-Winterization
To de -winterize the spa, reverse the Winterization procedure. Rell to the
water level mark.
WARNING: Whenever relling the spa, it will be necessary to Super Sanitize
the new spa water. Instructions are found in the Water Chemistry section.
To Next Page
Loading...
