73
Program memory failure*
At Power-Up, the system has failed the Program Checksum Test. is indicates a problem with the rmware (operation program) and requires a service call.
The settings have been reset (Persistent Memory Error)*
Contact your dealer or service organization if this message appears on more than one powerup.
The clock has failed*
Contact your dealer or service organization.
Conguration error (Spa will not Start Up)
Contact your dealer or service organization.
The GFCI test failed (System Could Not Test the GFCI)
(North America Only) May indicate an unsafe installation. Contact your dealer or service organization.
A pump may be stuck on
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organization.
Hot fault
A Pump Appears to have been Stuck ON when spa was last powered. POWER DOWN THE SPA. DO
NOT ENTER THE WATER. Contact your dealer or service organization.
System-Related Messages
* is message can be reset from the topside panel.
To Next Page
