Page 6 For technical questions, please call 1-888-866-5797. Item 64008
Installation
Read the entire Important Safety Information section at the beginning of this document including all
text under subheadings therein before set up or use of this product.
Safe can be mounted to a wall and/or floor capable of supporting the weight of the Safe and its contents.
WARNING! Verify that installation surface(s) have no
hidden utility lines before drilling or driving fasteners.
1. Only install Safe on a stable, level, clean and
dry wall and/or floor capable of supporting
the weight of Safe and its contents.
2. Remove liner(s) from back and/or bottom Safe.
3. Locate mounting holes on back
and/or bottom of Safe.
Wall
Mounting
Holes
Floor
Mounting
Holes
4. Using the Safe as a template, mark locations
of mounting holes on mounting surface(s).
5. Secure Safe with fasteners appropriate for the
mounting surface, which are rated to support
the weight of the Safe and its contents.
To install with included concrete anchors:
Note: If mounting to both wall and floor, mount to
floor first using all four included anchors. Then mount
to wall with four more fasteners (not included).
Mounting to Floor:
• Using a masonry bit (sold separately) the same
diameter as the largest part of the anchor,
drill holes in marked locations, 1/4" deeper
than the length of the anchor’s sleeve.
• Remove nuts and washers.
• Using a hammer (sold separately), gently tap
anchors into holes with threads facing up.
• Place Safe over exposed ends of anchors,
then secure with Washers, Spring Washers
and Nuts. Tighten Nuts securely.
6. Replace liner(s).
Install Shelves
1. Install Shelf Brackets as desired. 2. Lay shelves on top of Brackets.
To Next Page
Loading...
