5
2
INITIAL SETUP
1. Remove drip tray and cover from the parts box. Attach
the cover to the drip tray, then slide under the front door
of the machine, engaging the rear of the drip tray into
the opening in the lower front of the machine.
2. Remove the espresso brew group from the parts box.
The notices on this dispenser should be kept in good condition. Replace unreadable or damaged labels.
00824.0002
00986.0000
WARNING
FAILURE TO COMPLY RISKS EQUIPMENT
DAMAGE, FIRE OR SHOCK HAZARD.
READ THE ENTIRE
OPERATING MANUAL BEFORE
USING THIS PRODUCT
00986.0000M 10/14 ©1994 Bunn-O-Matic Corporation
Use only on a properly protected
circuit capable of the rated load.
Electrically ground the chassis.
Follow national/local electrical codes.
Do not use near combustibles.
Do not deform plug or cord.
37881.0000
To reduce the risk of electric shock,
do not remove or open cover.
No user-serviceable parts inside.
Authorized service personnel only.
Disconnect power before servicing.
00656.0001
As directed in the International Plumbing Code of the
International Code Council and the Food Code
Manual of the Food and Drug Administration (FDA),
this equipment must be installed with adequate
backflow prevention to comply with federal, state
and local codes. For models installed outside the
U.S.A., you must comply with the applicable Plumbing
/Sanitation Code for your area.
WARNING
12368.0002
USER NOTICES
continued >
3
4
3. Place groove on lower front of brew chamber onto
mounting bar on espresso drive.
4. Rotate the top of group head toward rear of machine
until it snaps into place.
1
DRIP TRAY, BREW GROUP AND BEAN HOPPER
To Next Page
Loading...
Need help?
General
