Bunn MHG Series Programming Manual

3
PROGRAMMING
OPERATING CONTROLS
Grind Pad (a) – Pressing initiates a timed grind cycle.
Stop Pad (b) – Pressing ends the operation of the grinder.
Pads (c) – “Hidden” buttons used to navigate setup and programming menus.
Pads (d) – buttons used to navigate setup and programming menus.
Hopper/Batch Selector Pads (e) – Press buttons to select small, medium or large batch size.
• These pads are located on the circles showing small, medium and large brews on each side of the
grinder with a total of 6 pads. Selecting one of these pads will select the amount of grind
and the side from which to grind.
Example: Selecting the lower pad (small batch) on the left side will grind enough beans
from the left hopper of the grinder to brew the amount programmed into grinder.
Control Board
The control board determines the amount of beans that will leave the hopper in a grind cycle. The timer
portion can be adjusted to dispense a different amount from each hopper and each batch size. The
scale is from 0.4 to 99.9 seconds.
GRIND
STOP
a b
c
(left)
d
e
c
(right)
e

Bunn MHG Series Specifications

General

Brand	Bunn
Model	MHG Series
Category	Grinder
Language	English