8
Test Frequency
The menu screen is used to see and test the frequency value for the read/write coils that may or may not be on
the equipment. The read/write capability operates between 124 to 127 Khz. To access Test Frequency:
1. Ensure machine is powered on.
2. Access programming.
3. The first screen should read “NAME HOPPER”. Use the right hidden button to navigate to “SERVICE”.
4. At the “SERVICE” screen, press SELECT.
5. The next screen will read “TEST OUTPUTS”. Select the right hidden button to navigate to
“TEST FREQUENCY”. Press SELECT.
6. Use the left, center and right buttons under the display to view the frequency of the component.
Grind Counters
This menu displays analytics in regards to total grinds, total grinds per batch or side, as well as flavor counts.
To access Grind Counters:
1. Ensure machine is powered on.
2. Access programming.
3. The first screen should read “NAME HOPPER”. Use the right hidden button to navigate to “SERVICE”.
4. At the “SERVICE” screen, press SELECT.
5. The next screen will read “TEST OUTPUTS”. Select the right hidden switch to navigate to “GRIND COUN-
TERS”. Press SELECT.
6. Use the right button under the display to navigate through the information presented on the display.
Note: The values displayed can be reset using the left hidden switch (reset).
Serial Asset Number
This function allows the operator to enter in an optional asset number. This can be useful for tracking the us-
age or service of an individual machine within a group. To access Serial Asset Number:
1. Ensure machine is powered on.
2. Access programming.
3. The first screen should read “NAME HOPPER”. Use the right hidden button to navigate to “SERVICE”.
4. At the “SERVICE” screen, press SELECT.
5. The next screen will read “TEST OUTPUTS”. Select the right hidden button to navigate to “SERIAL ASSET
NUMBER”. Press SELECT.
6. The next screen to appear is “ENTER ASSET #”. Use the left and right buttons under the display to
change the values. Select DONE when complete.
7. The next screen to appear is “SERIAL-ASSET #”. Use the left and right buttons under the display to
change the values. Select the DONE when complete.
NOTE: When a hopper or Smart Funnel is in place, an asterisk (*) will appear next to the “Adj”.
LEFT FREQUENCY
125.7 Khz Adj 1
Left Frequency Pertains
to the left bean hopper.
LEFT FREQUENCY
125.7 Khz Adj 1
Center Frequency
Pertains to the
Smart Funnel.
RIGHT FREQUENCY
125.7 Khz Adj 1
Right Frequency Pertains
to the right bean hopper.
LEFT FREQUENCY
125.7 Khz *Adj 1
The asterisk indicates
the grinder detects the
component.
To Next Page
Loading...
Need help?
General
