CORRECT
(Seal visible and
not obstructed)
INCORRECT
(Seal partially obstructed
by Sprayhead)
INCORRECT
(Seal behind Sprayhead)
reassembling the sprayhead
/
seal
If Sprayhead and Seal are separated during removal or cleaning, they must be reassembled
properly for My Café
®
Coffee Maker to function.
1. Identify the top of the Seal – it will have
rough ridges while the bottom is smooth
2. Identify the top of the Sprayhead – it has
a star pattern and a threaded hole where
the Sprayhead attaches to the Coffee
Maker.
3. Guide the Sprayhead into the channel of
the Seal. Gently stretch the Seal if needed.
Make sure it is completely in the channel.
When properly assembled, the Sprayhead
will slide easily into the channel of the
Seal and will not cause any buckles in the
surface of the Seal.
CAUTION: Improper reassembly
could result in personal injury from
hot water.
CLEANING & MAINTENANCE
storing the coffee maker
Unplug the Coffee Maker and wait for it to cool. It must be stored above 40°F/4°C to prevent
damage to the internal Hot Water Tank. If you do not use your Coffee Maker for an extended
period of time, we recommend running two to three cycles of water through prior to brewing
coffee or tea.
NOTE: After Initial Set Up, water will remain in the internal Hot Water Tank.
11
cleaning water probes
There are two stainless steel Water Probes in the Pour-In Bowl that are designed to detect if
water is present. Minerals from the water you use may build up in the Pour-In Bowl and on the
probes and may cause the Coffee Maker to incorrectly read that water is in the Pour-In Bowl.
1. Unplug the Coffee
Maker and allow it to
cool (minimum 1 hour).
Then rotate the Spin
Lid open.
2. Remove the 2 screws
in the Pour-In Bowl
with a Phillips head
screw driver.
3. Remove top of the
Pour-In Bowl by lifting
the front edge up
slightly, sliding the lid
back to unhook it and
then lift off.
4. Gently scrub the Water
Probes and surrounding
area with a textured
sponge or a toothbrush
to remove deposits.
5. Replace top of Pour-In
Bowl by sliding forward
until rear catch engages,
then lower the front of
the lid.
6. Re-install the screws
to the Pour-In Bowl
lid. Perform Coffee
Maker Maintenance as
directed on page 10.
To Next Page
Loading...
Need help?
General
