cleaning the sprayhead
Mineral deposits and loose coffee or tea granules may clog the Sprayhead, causing the brew
cycle to slow.
1. Insert any Drawer.
2. Open Spin Lid on top of Coffee Maker.
3. Fill Pour-in Bowl with 14 oz. white vinegar.
4. Close Spin Lid.
5. Place empty cup (greater than 14 oz. on
the base.
6. Push Brew Button to cycle vinegar
through Coffee Maker.
7. Run three or more additional 14 oz. cycles
of water through Coffee Maker to flush
remaining vinegar from Coffee Maker.
8. Follow the steps below to clean
the Sprayhead.
1. Unplug the Coffee Maker and allow it to
cool (minimum 1 hour).
2. Remove Drawer.
3. Facing the Coffee Maker, rotate the
Sprayhead clockwise (using your fingers)
until the Sprayhead and Seal are removed.
4. Clean Sprayhead and Seal with mild
detergent and rinse thoroughly.
A toothpick may also be used to clear
debris from Sprayhead holes.
CAUTION: If the Sprayhead and
Sprayhead Seal are separated,
they must be reassembled. Improper
reassembly could result in injury from
scalding water
5. Replace Sprayhead. rotate the Sprayhead,
counter-clockwise until finger tight.
6. Replace Drawer.
7. Plug in Coffee Maker to restore power.
CLEANING & MAINTENANCE
Rinse the Drawer(s) after each use. Drawers, Drip Tray and Drip Tray Cover are top rack
dishwasher safe. Occasionally wipe outside of the Coffee Maker with a mild, no citrus added
dish soap and a damp cloth.
coffee maker cleaning
Clean your Coffee Maker at least every 3 months. Mineral deposits may accumulate due
to impurities in the water used to brew. If deposits are not removed, they can impair the
operation of the Coffee Maker and reduce product life. The frequency of internal system
cleaning depends on the mineral content of your water (the higher the mineral content, the
more often you should perform Coffee Maker maintenance).
10
inspecting the sprayhead seal
When disassembling your Coffee Maker for cleaning, inspect the Sprayhead Seal for cracks,
tears and holes. Although the Seal should last for an extended period of time, damage can
occur through handling.
CAUTION: To prevent injury from hot water, do not use the unit if the Seal is damaged.
If damaged, call Customer Service at 800-352-2866 or visit retail.bunn.com to
obtain a replacement Seal.
To Next Page
Loading...
Need help?
General
