REASSEMBLING THE SPRAYHEAD
/
SEAL
If Sprayhead and Seal are separated during removal or cleaning, they must be reassembled
properly for My Café
®
brewer to function.
1. Identify the top of the Seal – it will have
rough ridges while the bottom is smooth
2. Identify the top of the Sprayhead – it has
a star pattern and a threaded hole where
the Sprayhead attaches to the brewer.
3. Guide the Sprayhead into the channel of
the Seal. Gently stretch the Seal if needed.
Make sure it is completely in the channel.
When properly assembled, the Sprayhead
will slide easily into the channel of the
Seal and will not cause any buckles in the
surface of the Seal.
CAUTION: Improper reassembly
could result in personal injury from
hot water.
CLEANING & MAINTENANCE
INSPECTING THE SPRAYHEAD SEAL
When disassembling your brewer for cleaning, inspect the Sprayhead Seal for cracks, tears
and holes. Although the Seal should last for an extended period of time, damage can occur
through handling.
CAUTION: To prevent injury from hot water, do not use the unit if the Seal is damaged.
If damaged, call Customer Service at 800-352-2866 or visit www.bunnathome.com to
obtain a replacement Seal.
STORING THE BREWER
Unplug the brewer and wait for it to cool. It must be stored above 40°F/4°C to prevent
damage to the internal Hot Water Tank. If you do not use your brewer for an extended
period of time, we recommend running two to three cycles of water through prior to
brewing coffee or tea.
NOTE: After Initial Set Up, water will remain in the internal Hot Water Tank.
11
To Next Page
Loading...
Need help?
General
