USE & CARE INSTRUCTIONS for ThermoFresh
®
SERVER
with MECHANICAL SIGHT GAUGE
STEP 9
STEP 8
STEP 5
Remove the faucet handle/
stem assembly by unscrew-
ing the faucet nut.
Disassemble the faucet/
stem assembly. Thoroughly
wash all faucet parts, drip
tray and cover in a mild
detergent and water solu-
tion. Rinse the parts in hot
water. Sanitize the parts for
five minutes, then air dry
completely.
DAILY CLEANING (Continued)
Remove the drip tray and
drip tray cover. Thoroughly
wash in a mild detergent
and water solution. Rinse
the parts in hot water.
STEP 6
Push sight gauge cap up
and pull tube from the
shroud. Remove the
grommet from the tube
and clean thoroughly.
STEP 10
Reassemble the faucet and
attach it to the dispenser.
CAUTION: When
reassembling, DO NOT
over-tighten faucet
bonnet. Hand tighten only.
STEP 11
Wash the entire outside
surface of the server with
a soft, non-abrasive cloth.
Do NOT clean with a water
jet device.
STEP
7
Wash the entire outside
surface of the lid assembly
with a mild detergent, water
solution, and a soft, non-
abrasive cloth and rinse
with hot water.
Do not submerge.
RELEASED FOR PRODUCTION
DIR Num: 39483.0008 22, January 2019
To Previous Page
Loading...
