12
08/54071/0 (ISSUE 2)
Heating up:
HEATING will flash on controller screen during the
heating up period. LOW TEMP may be shown on the
screen during this time. When selected temperature is
achieved – READY is shown.
Filling:
Once the INITIAL SET UP is complete, the filling process
will start. The LCD Screen will show the word FILLING.
After the filling is complete, the heating will start until it
reaches the set temperature. The LCD Screen will show
the word HEATING.
Filter Life (Filtration models only):
During operation, the bars fill to represent filter usage. Once
exhausted, all the bars are solid and the fault code for
changing the filter is displayed. The unit should be powered
down. Filters replaced and filter counter reset (refer to
replacement parts).
Power Down:
To power down the product, the STANDBY button should be
held when on the normal operation screen for 10 seconds.
The shutdown screen will appear and using the scroll
buttons, ‘Yes’ should be selected by pressing MENU. The unit
will then shutdown.
Tap function:
The tap can be changed between a controllable and constant
flow. For ‘Controllable’ flow, simply pull the plastic handle
towards from you to dispense water and release to stop, see
image 1. If you turn the plastic tap handle through 180 degrees,
the tap will be in ‘Constant’ mode, see image 2. Now when you
pull the tap towards you, it will remain locked downwards in an
‘open’ state until you lift the black handle back upwards to stop.
The tap function is the same on tap models on both our Filtered
and Unfiltered boilers.
Always take care when operating the tap as the water will
be boiling hot.
To Next Page
Loading...
