4
08/54071/0 (ISSUE 2)
DISCONNECT APPLIANCE BEFORE SERVICING,
MAINTENANCE OR CLEANING.
IF THE SUPPLY CORD IS DAMAGED, IT MUST BE
REPLACED BY THE MANUFACTURER, ITS SERVICE AGENT
OR SIMILARLY QUALIFIED PERSONS IN ORDER TO AVOID A
HAZARD.
DO NOT IMMERSE CORD, PLUG, OR WATER BOILER IN
WATER OR ANY OTHER LIQUID.
THE FLEXIBLE HOSE CONNECTED FROM THE OVER
FLOW ALSO ACTS AS A VENT FOR THE APPLIANCE. UNDER
NO CIRCUMSTANCES SHOULD THIS FLEXIBLE HOSE
BECOME BLOCKED OR RESTRICTED IN ANY WAY.
THIS APPLIANCE MUST ONLY BE USED FOR HEATING
WATER.
THE UNIT MUST BE INSTALLED ON A SOLID CONCRETE
/ BRICK OR OTHER SUITABLY ROBUST WALL, WITH
APPROPRIATE FITTINGS BY A QUALIFIED FITTER. THE
COMPANY DOES NOT ACCEPT ANY RESPONSIBILITY FOR
THE SAFETY OF ANY UNIT NOT INSTALLED IN THIS WAY.
DURING OPERATION PARTS & SURFACES MAY BECOME
HOT – AVOID ACCIDENTAL CONTACT.
THIS APPLIANCE IS NOT SUITABLE FOR OUTDOOR USE
OR AN AREA WHERE WATER JET COULD BE USED.
To Next Page
Loading...
