Why is my Bürkert Controller not working despite correct settings?
If the Bürkert Controller device isn't operating as a controller despite correct settings, it might be because the 'P.CONTROL' menu option is in the main menu. This makes the device function as a process controller, expecting a process actual value at the input. To resolve this, remove the 'P.CONTROL' menu option from the main menu.
What to do if the digital output of Bürkert Controller does not switch?
If the digital output of your Bürkert Controller isn't switching, the cause might be excessive current (greater than 100 mA) or a short-circuit. Check the digital output connection to resolve this.
How to fix 'Other device with the same address' error on Bürkert Controller?
If your Bürkert Controller shows that another device has the same address on the network, causing BUS offline issues, change the address of the device and restart it. You may also perform a fault analysis in the network using a bus monitor.
What to do if Bürkert Controller shows no supply pressure connected?
If your Bürkert Controller displays a message indicating that no supply pressure is connected and there is no change to the process variable, connect the supply pressure. Also, check the process and, if needed, switch on the pump or open the shut-off valve. Finally, check the process sensor.
Why can't Bürkert Controller find a configured partner?
If the Bürkert Controller indicates that a configured partner (Producer) cannot be found, verify that the configured partner is switched on and connected to the büS network. Also, check the bueS mapping using the Communicator.
What to do if compressed air failed during Autotune (X.TUNE) on Bürkert Controller?
If compressed air failed during Autotune (X.TUNE) on your Bürkert Controller, check the compressed air supply.
What to do if POS-MIN and POS-MAX are too close together on Bürkert Controller?
If the end positions for POS-MIN and POS-MAX are too close together on your Bürkert Controller, check the compressed air supply.
How to unblock X.TUNE function on Bürkert Controller?
If the X.TUNE function is blocked on your Bürkert Controller, input the access code.
What to do if I entered the wrong access code on Bürkert Controller?
If you've entered an incorrect access code on your Bürkert Controller, enter the correct access code.
What happens if maximum input value has been reached on Bürkert Controller?
If you've reached the maximum input value on your Bürkert Controller, do not increase the value further.
General| Brand | Burkert |
|---|---|
| Model | 8693 |
| Category | Valve Positioners |
| Language | English |
To Next Page
