Need help?Do you have a question about the Burkert 8630 and is the answer not in the manual?
General| Model | 8630 |
|---|---|
| Input Signal | 4-20 mA, 0-10 V |
| Communication Protocol | HART |
| Mounting | Direct mounting on linear or rotary actuators |
| Supply Pressure | 1.4-7 bar (20-100 psi) |
| Ambient Temperature Range | -20 ... +80 °C (-4 ... +176 °F) (depending on variant) |
| Housing Material | Aluminium |
Outlines essential safety precautions for operation and maintenance.
Details precautions to prevent ESD damage to sensitive components.
Explains how the device functions as a positioner, including control logic.
Describes the device's operation as an optional process controller.
Explains the device's function as an optional flow rate controller.
Provides technical specifications including operating conditions and electrical data.
Details the steps for connecting the pneumatic and fluidic aspects of the device.
Explains electrical connections using the multipole connector.
Details electrical connections using terminal blocks for cable bushings.
Outlines the initial configuration steps and basic settings for the device.
Guides through the initial setup and configuration of the device as a positioner.
Explains how to operate the device in different modes (AUTOMATIC, MANUAL).
Explains the automatic tuning process for the positioner.
Explains the automatic self-optimization process for the PID controller parameters.
Guides on configuring the PROFIBUS DP master and process values.
Guides on configuring input and output assemblies for DeviceNet data transmission.
Lists and explains error messages and potential causes.
Describes other common problems and their solutions.
To Next Page
