5
Burley Bee Owner’s Instruction and Safety Manual
IV. Unfolding and Folding Your Burley Bee
Your Burley Bee is designed with a super strong, lightweight aluminum frame, com-
plete with a roll cage and bright colored polyester software. Setting it up or folding
it down is accomplished in a few easy steps as follows:
Unfolding
To unfold, rotate the front tube upward and the rear tube back until they meet on
the two black plastic saddles as shown below. Then rotate the two frame locks to
snap onto the rear tube as shown below. The frame locks should connect adjacent
to, and to the outside of, the two plastic saddles.
Check that the frame locks are properly engaged before
using trailer. Failure to do so can result in serious injury.
Frame locks
snapped into
closed position
onto rear tube.
Frame Lock
Front
Rear
To Next Page
Loading...
