Burley DASH RM - Attaching Bicycle Seat to Bicycle

CHILD BIKE SEAT
ENG
8
Attaching the Bicycle Seat to Your Bicycle
1. Rotate the Adjustment Knob counter-clockwise [Figure 1] to open the Rack Clamp [Figure 2]
until it is wider than the bicycle rack the Bicycle Seat will be attached to.
2. Place the Bicycle Seat on the bicycle rack and position it so that it is properly aligned according
to the instructions for “Checking the Alignment of the Bicycle Seat” on Page 9.
3. Rotate the Adjustment Knob clockwise [Figure 3] until the Rack Clamp begins to secure around
the rack [Figure 4a]. Ensure that the Rack Clamp is properly fastened to the bicycle rack tubes.
4. Continue rotating the Adjustment Knob clockwise until the Bicycle Seat is securely attached to
the rack.
NOTE: During the last few rotations of the Adjustment Knob, the Locking Ring should make
audible clicking noises. When fully tightened, the Locking Ring should prevent the Adjustment
Knob from rotating counter-clockwise [Figure 4b].
Figure 1 Figure 2
Figure 3
Figure 4
B
A