ENG DEU FRA ESP
FLATBED
ASSEMBLY & USE
7
ASSEMBLY & USE
for TOC, do not delete. box must not extend to pages edges. don't forget to also add it to your pages panel
Push in the rubber button on the
outside of the wheel hub.
Push in the rubber button on the
outside of the wheel hub. Pull
wheel out of axle receiver.
Insert wheel axle into axle receiver,
and then release the button.
Pull firmly on wheel to confirm
the axle is fully engaged.
1 1
2
Attaching the Wheels Removing the Wheels
Attaching the Trailer to Your Bicycle
Quick Release or Nutted Axle:
Remove quick release skewer or axle
nut from left side of bike’s rear-wheel.
Install the hitch between quick release
or axle nut and frame with the hitch tabs
parallel to ground. Tighten quick release
or axle nut following bike manufacturer’s
recommendation.
Consult Burley.com for adapters
designed to help fit your trailer
to your bike if necessary.
Thru Axle:
Requires adapted thru axle to install
hitch. Consult Burley.com to obtain
proper fit and installation to your bike.
Hooking the tow bar to the hitch:
Insert flex connector in between
the two holes on the hitch. Insert
lock pin and close retainer.
1
2
note
The hitch can remain on the bike
when trailer is removed.
To Next Page
Loading...
