Installation / Service / User Manual BURNERTECH
11
4.3 Gas Installation
To Install the Gas supply to the Burner, follow the instruction bellow:
1. Remove the seal in front of the Gas connection flange at the rear of the burner
2. Check the thread on the flange and ensure that there is no debris in the threads
3. Connect the corresponding gas pipe/fittings to the Gas connection flange in the Burner.
4. Tighten the gas pipe/fittings and the Gas connection flange securely, ensuring that there is
no possibility for gas leakage.
To Next Page
Loading...
Need help?
General