Burster DIGIFORCE 9310 User Manual

DIGIFORCE 9310
PROFIBUS manual
Date 2004-04-28
©
2004
burster
präzisionsmeßtechnik gmbh &
co kg
All rights reserved
Manufacturer:
burster präzisionsmeßtechnik gmbh & co kg
Talstraße 1 - 5 Postfach 1432
76593 Gernsbach 76587 Gernsbach
Note:
The information contained in the following may be changed without prior notification. Reproduction
of any part of this document, or its processing using electronic systems is prohibited without prior
written approval. burster provides no warranty whatsoever for this equipment. This disclaimer also
applies to implied warranty for commercial quality and suitability for a specific purpose. burster is
not liable in any circumstance for faults contained therein, accidental damag
e or consequential
damage in connection with the operation or use of this equipment.

Burster DIGIFORCE 9310 Specifications

General

Sampling rate	10 kHz
Resolution	16-bit
Display	LCD
Data Output	USB, RS232
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 70°C

Summary

User Advice and Safety Instructions

Safety and Usage Guidelines

Covers important safety information and proper use of the equipment.

Technical Data

Electrical Safety and EMC

Covers electrical safety specifications and electromagnetic compatibility details.

Installation Guide

Fieldbus Connection and Installation

Details fieldbus line connection and installation procedures.

PROFIBUS DP System and Device Configuration

Covers PROFIBUS DP system configuration and DIGIFORCE 9310 menu.

PROFIBUS DP Overview

Introduction and Features

Provides an introduction to PROFIBUS DP, its types, and key features.

General Information and GSD File

Covers general PROFIBUS DP info, data transfer, and GSD file usage.

Data Conversion and Floating-Point Issues

PROFIBUS DP Data Protocol

Master to Slave Transfer and PLC Inputs

Explains master-to-slave transfer and PLC input byte details.

Slave to Master Message Structure

Details message structure and data transfer from slave to master.

Protocol Mode Content and PLC Outputs

Message Breakdown and Data Formats

PROFIBUS DP Byte Reference List

Mode 1 and Mode 2 Byte References

Mode 3 Byte Reference

Mode 4 Byte Reference (Window 1 E/E)

Mode 5 Byte Reference (Full General Curve Data, Window 1 E/E)

Mode 6 Byte Reference (Windows 1-2 E/E)

Mode 7 Byte Reference (Full General Curve Data, Windows 1-2 E/E)

Mode 8 Byte Reference (Windows 1-3 E/E)

Mode 9 Byte Reference (Full General Curve Data, Windows 1-3 E/E)