Fig. 6: Finishing
13. Position the cover on the housing.
14. Latch the cover to the bottom part.
Fig. 7: Earthing (if required)
15. Plug a 6.3 mm flat plug connector onto the rear of the earth connection contact (Pos. 5).
Fig. 8: Web version (if required)
16. Break off the fixing points that are not required with a suitable tool.
The cable is now installed.
Pos: 25 /Busch-Jaeger (Neustruktur)/Modul-S truktur/Online-Dok umentation/Steuer module - Onl ine-Dok umentation (--> Für alle Doku mente <--)/++++++++++++ Seitenumbruch ++++++++++++ @ 9\mod_1268898668093_0.docx @ 52149 @ @ 1
To Next Page
Loading...