Why is my BUSCH R5 RA 0165 D fuming or expelling oil?
If your BUSCH Water Pump is fuming or expelling oil droplets through the gas discharge, it could be due to a few reasons. The exhaust filters (EF) might be partially clogged, so try replacing them. Also, ensure that the exhaust filter (EF) with o-ring is correctly positioned. If the float valve (FV) isn't working properly, contact Busch for repair.
How to fix a noisy BUSCH R5 RA 0165 D?
If your BUSCH Water Pump runs very noisily, the coupling (CPL) might be worn and needs replacement. Stuck vanes or defective bearings could also be the cause, in which case you should contact Busch for repair.
General| Brand | BUSCH |
|---|---|
| Model | R5 RA 0165 D |
| Category | Water Pump |
| Language | English |
Explains how the rotary vane vacuum pump operates and its oil system.
Details the machine's purpose and limitations for industrial applications.
Describes the machine's control mechanism and optional starter units.
Mixes process gas with ambient air to counteract vapor condensation.
Protects the machine from dust and solids in the process gas.
Used for unfavorable ambient conditions to cool the oil.
Monitors the oil temperature with two switch points.
Monitors the oil temperature and signals warning/trip points.
Monitors the oil level and stops the machine if too low.
Monitors oil separator pressure and stops the machine if a threshold is reached.
Monitors oil separator pressure and signals warning/trip levels.
Specifies the required environmental and physical conditions for proper installation.
Details connection requirements for suction and discharge lines.
Details the connection requirements and safety precautions for the suction port.
Provides guidelines for connecting the discharge port and gas flow.
Describes the connection and requirements for the optional water-oil heat exchanger.
Instructions for filling the machine with the correct type and amount of oil.
Procedure for fitting the coupling between the motor and the pump shaft.
Explains electrical connection for machines equipped with an optional control box.
Details electrical connection for machines without a control box or VSD.
Instructions for electrical connection when a variable speed drive is included.
Provides wiring diagrams for three-phase motors in various configurations.
Wiring diagram for connecting an optional level switch for monitoring.
Wiring diagram for connecting an optional oil temperature switch.
Wiring diagram for connecting an optional resistance thermometer.
Wiring diagram for connecting an optional pressure switch.
Wiring diagram for connecting an optional pressure transmitter.
Wiring diagram for connecting water-oil heat exchanger pressure switch.
Procedure for commissioning the machine when conveying condensable vapors.
Outlines the recommended maintenance tasks and intervals for normal and harsh applications.
Procedure for checking the oil level in the vacuum pump.
Instructions for changing the oil and the oil filter.
Detailed steps for replacing the exhaust filters.
Procedure for cleaning the air heat exchanger.
Steps for safely dismantling and disposing of the machine.
To Next Page
