EasyManua.ls Logo

Bush Hog BH10 Series - User Manual

Bush Hog BH10 Series
140 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
© 2013 Alamo Group Inc.
BH10
SERIES
BH14, BH15, BH16, BH17
Published 03/13 Part No. 50070885
OPERATOR’S MANUAL
BUSH HOG
®
2501 Griffin Ave.
Selma, AL 36703
334-874-2700
www.bushhog.com
ROTARY MOWER
This Operator's Manual is an
integral part of the safe operation
of this machine and must be
maintained with the unit at all
times. READ,
UNDERSTAND, and
FOLLOW the Safety and
Operation Instructions contained
in this manual before operating
the equipment. C01-Cover_B
Important Operating
and Safety Instructions
are found in the Mower
Safety Video that can
be instantly accessed
on the internet at:
www.algqr.com/bve
$0.00

Table of Contents

Questions and Answers

  • M
    Marc MaddoxAug 16, 2025
    Why is my Bush Hog BH10 leaving an uneven cut?
    • A
      Austin LewisAug 16, 2025
      An uneven cut from your Bush Hog Lawn Mower can stem from several factors. You might be operating at excessive ground speed, which requires you to reduce your speed. The blades could be worn, dull, or bent, indicating they need replacement. The mower might not be level, necessitating an adjustment. Check if the mower height is improperly adjusted; if so, adjust it accordingly. Uneven tire pressure on the tractor, damaged mower pan, or turning too fast can also cause this issue. Adjust tire pressure, repair or replace the mower pan, or reduce ground speed when turning. Finally, tractor tires may be pushing the grass down; adjust your tractor wheel spacing.
  • B
    Brent FergusonAug 19, 2025
    Why is my Bush Hog BH10 Lawn Mower not cutting material?
    • A
      Amanda PetersonAug 19, 2025
      If your Bush Hog Lawn Mower is not cutting material, it could be due to excessive ground speed, so reduce it. Ensure you are using full PTO speed. Also, check that the blades are installed correctly for the direction of cut.
  • D
    Derrick SmithAug 22, 2025
    What causes streaking conditions with my Bush Hog Lawn Mower?
    • A
      Angela MillerAug 22, 2025
      Streaking while using your Bush Hog Lawn Mower can occur if conditions are too wet, so allow the grass to dry before cutting. It may also happen if the blades are dull, so sharpen or replace them. Another cause can be the height of the cutter being lower at the rear or front, or if the blades are too slow relative to the tractor's ground speed. Lowering the cutting height may help.
  • M
    Mrs. Jill Martin MDAug 25, 2025
    Why is my Bush Hog Lawn Mower not shredding properly?
    • D
      Danielle HaynesAug 26, 2025
      Poor shredding with your Bush Hog Lawn Mower can result from excessive ground speed. Try raising the front of the mower relative to the rear to hold and circulate material longer, and reduce ground speed. Also, if you are cutting too high, lower the cutting height.
  • R
    Raymond AlvaradoAug 28, 2025
    What to do if my Bush Hog BH10 gearbox is leaking?
    • K
      Keith RamirezAug 28, 2025
      If your Bush Hog Lawn Mower gearbox is leaking, there are several potential causes. The oil seal might be damaged, installed incorrectly, or not sealing properly in the housing, requiring replacement or the use of a sealant. A bent shaft or a rough oil seal race also necessitates replacement or repair. Other possible causes include a damaged gasket, loose bolts, a sand hole in the casting, or an oil level that is too high. Replace the gasket, tighten the bolts, replace the castings or gearbox, or drain the oil to the proper level.
  • D
    David YoungAug 31, 2025
    Why does my Bush Hog Lawn Mower keep shearing pins?
    • C
      cjacksonAug 31, 2025
      Shear pin shearing in your Bush Hog Lawn Mower can occur due to several reasons: * The tractor PTO might not be running at 540 RPM – ensure it is. * You may be dealing with heavy material – reduce ground speed. * An incorrect shear pin may be in use – replace it with the recommended one. * The PTO might be engaged at high engine RPM – idle the engine before engaging. * Rocky conditions may be present – increase cutting height. * The blade carrier RPM might be too high – check gearbox ratios.
  • D
    Daniel NicholsSep 3, 2025
    Why is my Bush Hog Lawn Mower gearbox noisy?
    • M
      Mrs. Kelli RichmondSep 3, 2025
      A noisy gearbox in your Bush Hog Lawn Mower can be attributed to a few reasons. The lubricant level might be low, so check and replenish it. The gears could be rough, requiring a run-in or change. Alternatively, a worn bearing might be the cause, which would need replacement.
  • S
    stacythomasSep 6, 2025
    Why is my Bush Hog BH10 windrowing?
    • I
      Isabella GarciaSep 6, 2025
      Windrowing with your Bush Hog Lawn Mower can occur if the material is heavy and lush. In this case, try raising the front of the mower relative to the rear. Excessive ground speed can also cause windrowing, so reduce your speed. Wet conditions may also contribute, so wait for the conditions to dry.
  • K
    katherine72Sep 9, 2025
    Why are the blade bolts on my Bush Hog BH10 Lawn Mower working loose?
    • E
      Earl BauerSep 9, 2025
      If the blade bolts on your Bush Hog Lawn Mower are working loose, it could be because they weren't tightened sufficiently; tighten the bolts to 600 ft./lbs. Alternatively, the bolt hole may be elongated or oversized, requiring replacement of the blade carrier. A broken lockwasher can also cause this issue, so replace the lockwasher.
  • K
    kellycastroSep 12, 2025
    Why is my Bush Hog BH10 Lawn Mower gearbox overheating?
    • C
      Caitlin Hernandez DDSSep 12, 2025
      Gearbox overheating in your Bush Hog Lawn Mower can be due to low lubricant, so fill it to the level plug. It may also happen if the lubricant type is incorrect, so replace it with the proper lubricant. Excessive trash build-up around the gearbox can also cause overheating, so remove any trash.

Bush Hog BH10 Series Specifications

General IconGeneral
BrandBush Hog
ModelBH10 Series
CategoryLawn Mower
LanguageEnglish

Related product manuals