OPERATION
DHM7 05/21 Operation Section 4-32
© 2021 Alamo Group Inc.
OPERATION
13. MOWER STORAGE
Properly preparing and storing the mower at the end of the season is critical to maintaining its appearance and
to help ensure years of dependable service. The following are suggested storage procedures:
• Thoroughly clean all debris off the mower to
prevent damage from rotting grass and
standing water.
• Lubricate all mower grease points and fill
gearbox oil levels as detailed in the
maintenance section.
• Tighten all bolts and pins to the recommended
torque.
• Check the mower for worn and damaged
parts. Perform repairs and make replacements
immediately so that the mower will be ready
for use at the start of the next season.
• Store the mower in a clean, dry place with the
mower housing resting securely on blocks or
at ground level.
• Keep the driveline yoke from sitting in water,
dirt and other contaminants.
• Loosen the trapezoidal belts and check the
protection plate is lying flat.
Use spray touch-up enamel where necessary to
prevent rust and maintain the appearance of the
mower.
14.1 Transporting the Mower
Make sure that no person or object is standing within the turnover range of the disk carrier
bar.
Before transporting the machine on public roads, the user must always make sure that it
complies with highway regulations.
Never allow children or other persons to ride on the Tractor or Implement.
Falling off can result in serious injury or death. (SG-10)
14. TRANSPORTING THE TRACTOR AND IMPLEMENT
Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind
when you finish working in an area. Therefore, the operator must employ good judgement and safe operation
practices when transporting the tractor and implement between locations. By using good judgement and
following safe transport procedures, the possibility of accidents while moving between locations can be
substantially minimized. OPS-U- 0017
To Next Page