Installation
Positioning
1. Make sure that there are no combustible or
flammable materials, such as curtains, in the
vicinity of the installation.
2. Furniture and cabinets surrounding the oven
must be of material resistant to temperatures
greater than 100 °C.
3. Surrounding furniture, cabinets and extractor
fans should be positioned in accordance with
the diagram shown in figure 1.
4. There must be at least 2cm of free space
between the back wall and the rear of the
appliance to allow for ventilation and air
circulation.
5. If fitted, the extractor fan must be at least 65cm
above the hob. If no fan is fitted the minimum
distance between the hob and any cabinet or
other structure must be 70cm.
Feet height adjustment
1. The height and level of the appliance can be
adjusted by rotating the feet located underneath
the appliance at each corner as shown in figure
2.
2. Rotate in a clockwise direction to decrease the
height and anti clockwise to increase the height.
3. Once the desired level has been achieved make
sure to lift the appliance into its location. Do not
drag it as this may cause damage to your floor
and the appliance.
Positioning & electrical connection
Customer Helpline 0845 600 4632
Figure 1
See detail A
Detail A
Figure 2
6
To Next Page
Loading...
