IMPORTANT – Electrical connections must be
carried out by a suitably qualifi ed person and in
accordance with all relevant local building and
installation regulations.
Electrical connections
This appliance is fi tted with fused plug which1.
should be inserted into a suitable mains socket.
It is recommended that the mains socket is2.
located behind the appliance and is switched
on and off via a separate switched Fused
Connection Unit (FCU).
It is recommended that the switched FCU3.
is located adjacent to the appliance within a
maximum distance of 2m. The switched FCU
must not be located above the appliance
but should be easily accessible in case of an
emergency.
Electrical connection
Installation
C
ustomer Helpline 0345 257 7271
Securing the oven
To prevent the appliance tilting a stability chain
should be connected to the rear of the appliance.
The stability chain is not supplied with the
appliance.
Remove the screw on the rear of the1.
appliance as shown in fi gure 4.
Align the stability chain with the screw hole.2.
Refi t the screw to the rear of the appliance.3.
Secure the opposing end of the stability4.
chain to a wall using a suitable fastener
Figure 4
6
To Next Page
Loading...
