EasyManua.ls Logo

Bush CTT939 - User Instructions; Troubleshooting

Bush CTT939
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 9
User instructions
Troubleshooting
In the unlikely event of difficulties with your appliance please follow the trouble shooting guide below.
If the problem persists, visit the technical support website: www.argos-support.co.uk
Problem Reason(s) Solution(s)
No power
• Power cable not connected to
wall socket
• Power socket is not switched on
• The power saving mode is
activated.
• Make sure the plug is connected
• Switch the power on
• See ’Mains connection’ page 5 for
details.
No sound when connected to
a home stereo system
• Volume is too low
• The RCA cables are not connected
correctly.
• The stereo system is not set to the
correct input mode.
• Increase the volume
• Check the connections.
• Check which input you connected the
RCA cables to and switch to that input
mode on your stereo system.
No sound when connected to
a computer
• The device was not recognised
when connected.
• The software playthorugh option
was not ticked.
• The recording level bar was not
clicked.
• Re-boot the computer and try again.
• See page 7 ‘Setting up the device on a
computer section 5’ for details.
• See page 7 ‘Setting the recording
levels section 2’ for details.
The start or stop position is
not accurate
• The tone arm alignment is not set
correctly.
• See page 6 for instructions on
alignment.
Recordings made through a
computer are distorted
• The input levels are too high • Adjust the input levels. See page 7
‘Setting the recording levels’.
The stylus is skating across
the record
• The counter weight is not set
correctly.
• Adjust the counterweight. See page 4
‘Installing the counter weight’.
The record is playing too fast
or too slow.
• The pitch adjustment needs fine
tuning.
• Increase or decrease the pitch adjust
control. See page 5 ‘Pitch adjust’.