Bush DLED32HDSC - Settings Menu Content

Settings Menu Content
Picture Menu Content
Mode
You can change the picture mode to suit your preference or requirements. Picture mode
can be set to one of these options: Cinema, Game, Sports, Dynamic and Natural.
Note: Available options may dier depending on the input source.
Contrast Adjusts the light and dark values on the screen.
Brightness Adjusts the brightness values on the screen.
Sharpness Sets the sharpness value for the objects displayed on the screen.
Colour Sets the colour value, adjusting the colours.
Energy Saving
For setting the Energy Saving to Custom, Minimum, Medium, Maximum, Auto, Screen
O or O.
Note: Available options may dier depending on the selected Mode.
Backlight
This setting controls the backlight level. The backlight function (will be located under
the Energy Saving setting) will be inactive if the Energy Saving is set to an option other
than Custom.
Picture Zoom Sets the desired image size format.
Picture Shift
This option (will be located under the Picture Zoom setting) may be available depending
on the Picture Zoom setting. Highlight and press OK, then use directional buttons to shift
the picture upwards or downwards.
PC Position Appears only when the input source is set to VGA/PC.
Autoposition
If the image is not centred in VGA mode use this option to automatically adjust the position
of the image. Press OK to start the auto adjustment.
H Position This item shifts the image horizontally to the right hand side or left hand side of the screen.
V Position This item shifts the image vertically towards the top or bottom of the screen.
Dot Clock
Dot Clock adjustments correct the interference that appear as vertical banding in dot
intensive presentations like spreadsheets or paragraphs or text in smaller fonts.
Phase
Depending on the input source (computer, etc.) you may see a hazy or noisy picture on
the screen. You can use phase to get a clearer picture by trial and error.
Advanced Settings
Dynamic Contrast You can change the dynamic contrast ratio to desired value.
Colour Temp
Sets the desired colour temperature value. Cool, Normal, Warm and Custom options
are available.
White Point
If the Colour Temp option is set as Custom, this setting will be available (will be located
under the Colour Temp setting). Increase the ‘warmth’ or ‘coolness’ of the picture by
pressing Left or Right buttons.
Tru Blue
White colour enhancement function that makes white colour more cooler in order to
make more bright picture. Set as On to enable.
Tru Micro Dimming
Low, Medium, High and O options are available. While Tru
Micro Dimming is active, it
will enhance contrast locally for each defined zone.
Noise Reduction
Low, Medium, High and O options are available. If the signal is weak and the picture is
noisy, use the Noise Reduction setting to reduce the amount of noise.
Film Mode
Films are recorded at a dierent number of frames per second to normal television
programmes. Turn this feature on when you are watching films to see the fast motion
scenes clearly.
Skin Tone Skin tone can be changed between -5 and 5.
Advanced features
Getting the most from your TV
Advanced features
26
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105, a Bush enquiry line.