Bush DWFSE126W - Page 25

Using your Dishwasher
Getting the most from your appliance
Using your Dishwasher
Getting the most from your appliance
5.4. Test Strip
Run water through
the tap (1min.)
Keep the strip in
the water (1sec)
Shake the strip. Wait (1min.)
Set the hardness level of
your machine.
1
2
3
4
5
6
1
munite
1
second
1
munite
1
°
dH=1.25
°
Clarke=1.78
°
fH=0.178mmol/l
The default setting: H3
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 55
GermanGerman
dHdH
0 - 9
10 - 20
21 - 30
31 - 40
41 - 60
61 - 98
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
FrenchFrench
fHfH
Mmol/lMmol/l
BritishBritish
ClarkeClarke
WATER HARDNESS
Salt consumption
(gram/cycle)
H1
H2
H3
H4
H5
H6
0
9
12
20
30
60
No regeneration
Water softner
level
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
1)
Regeneration occurs
every X program
sequence
1)
10
5
3
2
1
5.6. Water Softener System
The dishwasher is equipped with a water softener which reduces the hardness in the
mains water supply. To find out the hardness level of your tap water, contact your water
company or use a test strip (if available).
NOTE: The default hardness level setting is “3”. If the water is well water or has a hardness
level above 90 dF, we recommend that you use filter and refinement devices.
5.5. Water Hardness Table
Using your Dishwasher
25
or onl
in
e
at www.bush-support.com If you still require further assistance, call one of our experts on 0
345 257 7271.