20
21
Using your Tower Speaker
Using your Tower Speaker
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Tower Speaker
Let’s get started
Using your Tower Speaker
Let’s get started
Bluetooth mode
Check that your Tower Speaker is in Bluetooth mode. If you are not already in Bluetooth
mode, press and release the Mode button on the Tower Speaker or on the Remote
control until you are in Bluetooth mode (check the display).
Listening to Music/Audio using Bluetooth
In Bluetooth (BT) Mode:
1. Select and start the music or audio that you wish to listen to on your paired Bluetooth
device, it will now be heard through the Tower Speaker. Adjust the volume on the
connected device and/or your Tower Speaker.
Note: If your previously paired device is within range but does not automatically
connect, go to the Bluetooth connectivity settings on your device and select Bush
Tower to reconnect.
2. You can use the controls on your paired Bluetooth device as well as those on your
Tower Speaker and Remote control. .
Controls available on your Tower Speaker and Remote control:
• Volume:
• Press and release the button to increase the volume in steps
• Press and hold the button to progressively increase the volume
• Press and release the button to decrease the volume in steps
• Press and hold the button to progressively decrease the volume.
• Check the display, which will confirm the volume level. 32 is the maximum
volume level.
• Play/Pause:
• Press and release the button to play/pause.
• Skip back:
• Press and release to skip back to the previous track.
• Skip forward:
• Press and release to skip forward to the next track.
Note: If you do not use your Tower Speaker for approximately 20 minutes and no
audio signal is received, it will automatically go to Standby mode. Press and release the
button on the Tower Speaker or on the Remote control to switch the Tower Speaker
back on.
Aux in mode
Check that your Tower Speaker is in Aux in mode. If you are not already in Aux in mode,
press and release the Mode button on the Tower Speaker or on the Remote control until
you are in Aux in mode (check the display).
1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or
auxiliary out) socket of your secondary device, connect the other end to the Aux in
socket on the back and at the top of your Tower Speaker.
2. Press the play button on your external device to start playback through the Tower
Speaker.
3. To gain optimal volume levels, adjust the volume level on both the secondary device
and on the Tower Speaker.
Note: It is recommended that you unplug the audio cable from the Aux in socket
on the back of the Tower Speaker, after you have finished listening to your external
secondary device.
To Next Page
Loading...
