20
21
Using your Tower Speaker
Using your Tower Speaker
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Tower Speaker
Let’s get started
Using your Tower Speaker
Let’s get started
Bluetooth mode
Check that your Tower Speaker is in Bluetooth mode. If you are not already in Bluetooth
mode, press and release the M button on the Tower Speaker or the Mode button on the
Remote control to switch to Bluetooth mode (Blue LED).
Listening to Music/Audio using Bluetooth
In Bluetooth (BT) Mode:
1. Select and start the music or audio that you wish to listen to on your paired Bluetooth
device, it will now be heard through the Tower Speaker. Adjust the volume on the
connected device and/or your Tower Speaker.
Note: If your previously paired device is within range but does not automatically
connect, go to the Bluetooth connectivity settings on your device and select BUSH
HT-701 to reconnect.
2. You can use the controls on your paired Bluetooth device as well as those on your
Tower Speaker and Remote control. .
Controls available on your Tower Speaker and Remote control.
• Play/Pause:
• Press and release the button to play/pause.
• Skip back (Tower speaker) :
• Press and hold the - button to skip back to the previous track.
• Skip back (Remote control) :
• Press and release the button to skip back to the previous track.
• Skip forward (Tower speaker):
• Press and hold the + to skip forward to the next track.
• Skip forward (Remote control
• Press and release the button to skip forward to the next track.
Note: If you do not use your Tower Speaker for approximately 20 minutes and no
audio signal is received, it will automatically go to Standby mode. Press and hold the
button on the Tower Speaker or press and release the button on the Remote
control to switch the Tower Speaker back on.
Aux-in mode
Check that your Tower Speaker is in Aux-in mode. If you are not already in Aux-in mode,
press and release the M button on the Tower speaker or the Mode button on the Remote
control until you are in Aux-in mode (Blue/Red LED).
1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or
auxiliary out) socket of your secondary device, connect the other end to the Aux-in
socket on the top of your Tower Speaker.
2. Press the play button on your external device to start playback through the Tower
Speaker.
3. To gain optimal volume levels, adjust the volume level on both the secondary device
and on the Tower Speaker.
Note: It is recommended that you unplug the audio cable from the Aux-in socket
on the top of the Tower Speaker, after you have finished listening to your external
secondary device.
To Next Page
Loading...
