14
15Getting to know your Tower Speaker
Getting to know your Tower Speaker
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Getting to know your Tower Speaker
You’ll be up and running in no time
Getting to know your Tower Speaker
You’ll be up and running in no time
Power connection
Note: Before you connect the power, you must first attach the Tower speaker to the
separate base using the screws supplied.
1. Connect the mains power lead into the socket on the back of the Tower Speaker.
2. Plug the power adaptor into the mains power wall socket and switch on.
3. The blue LED on the top panel, in front of the AUX socket will begin to flash whilst
your Tower Speaker begins to search for Bluetooth devices.
Remote control
1. Pull out the safety strip on the remote control to activate the battery.
Initial set-up
In Standby mode:
1. If your product is in Standby mode (Red LED), press and hold the button on the top
of the Tower Speaker or press and release the on the Remote control. The first time
you switch on your product, it will power up in Bluetooth mode. The blue LED on
the top panel, in front of the AUX socket will begin to flash whilst your Tower Speaker
begins to search for Bluetooth devices.
Connect to a Bluetooth device
In Bluetooth (BT) Mode:
1. When the blue LED on the top of the Tower Speaker is flashing,
2. On the device that you would like to connect to your Tower Speaker via Bluetooth
(e.g. iPhone/ iPad/Android/other phone/Tablet/Computer), turn on Bluetooth
connectivity and ensure that it is ‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.
4. When found, your Tower Speaker will be displayed as ‘BUSH HT-701’. Select the device
name to begin pairing.
Note: If your device requests a password, please enter ‘0000’ to complete the device
pairing.
5. When pairing is complete you will hear an audible alert, the blue LED will stop flashing
and will remain constantly on.
6. Now that you have paired your device with the Tower Speaker, it will connect to it
when it is within range, which is about 10 metres or less (33 feet or less), line of sight.
7. Your device will remain paired with the Tower Speaker unless you decide to
disconnect or ‘unpair’ it.
Note: If your Tower Speaker becomes disconnected from the other Bluetooth device
at any time, the blue LED will begin to flash as it searches for a Bluetooth connection,
select ‘BUSH HT-701’ on the device you wish to connect to reconnect.
Note: You can press and hold the button for 3 seconds to unpair your current
device and search for new devices.
Change the mode
On the Tower Speaker or on the Remote control:
• Press and release the M button on the Tower Speaker or the Mode button on the
remote control to change between Bluetooth and Aux-in modes.
Blue LED: Bluetooth mode
Blue/Red LED: Aux-in
Red LED: Standby mode
To Next Page
Loading...
