This page is left intentionally blank
16
Getting to know your Tower Speaker
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on0345 600 3021
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Getting to know your Tower Speaker
You’ll be up and running in no time
Note: You must connect an Aux-in cable (not supplied) to the Aux-in socket on the top
of the product, to use Aux-in mode.
Adjusting the volume
On the Tower Speaker or on the Remote control:
• Press and release the + button on the Tower Speaker or the button on the remote
control to increase the volume in steps.
• Press and hold the button on the remote control to progressively increase the
volume.
• Press and release the - button on the Tower Speaker or the button on the remote
control to decrease the volume in steps.
• Press and hold the button on the remote control to progressively decrease the
volume.
Mute
On the Remote control:
• Press and release the button to mute the volume.
• Press and release the button to turn the sound on again
Change the EQ setting
On the Remote control (Bluetooth mode only).
• Press and release the EQ button to change the EQ setting. There are 6 options
available: Movie, Rock, Jazz, Classical, Country and Flat.
To Next Page
Loading...
