Bush PT-941 - Bluetooth Connectivity; Power Management; Bluetooth Audio Playback

18
19
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Party Speaker
Using your Party Speaker
Using your Party Speaker
Let’s get started
Using your Party Speaker
Let’s get started
Power on
After you have connected the power to the Party speaker, press the power switch on
the back of the Party speaker at the top to On. The product will switch on, ‘Hi’ will be
displayed followed by ‘-bt-’, a bluetooth icon will flash to indicate that you Party speaker is
searching for Bluetooth devices.
Standby mode
If the Party Speaker does not receive an audio signal for approximately 20 minutes, it will
go to Standby mode. Short press the Power/M button to turn the product back on
again.
Power o
Long press the Power/M button and then switch the power switch on the back of
the Party speaker to off. To power off the product completely,when using mains power,
switch off at the mains power wall socket.
Connect to a Bluetooth device
Check that your Party speaker is in Bluetooth mode. If you are not already in Bluetooth
mode, short press the Power/Mode button until you are in Bluetooth mode (check the
display). Your Party speaker will begin to search for Bluetooth devices.
In Bluetooth Mode:
1. Your Party speaker will search for Bluetooth devices.
2. On the device that you would like to connect to your radio (e.g. iPhone/iPad/Android/
other phone/Tablet/Computer), turn on Bluetooth connectivity and ensure that it is
‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.
4. When found, your Party speaker will be displayed as ‘BUSH PT-941’. Select the device
name to begin pairing.
5. When pairing is complete ‘Connected’ will be announced and the bluetooth icon will
stop flashing and will remain continuously on.
6. Now that you have paired your device with the radio, it will connect to it when it is
within range, which is about 10 metres or less (33 feet or less), line of sight.
Your device will remain paired with the Party speaker unless you decide to disconnect or
‘unpair’ it.
Listening to Music/Audio using Bluetooth
In Bluetooth mode:
1. Select and start the music or audio that you wish to listen to on your paired Bluetooth
device, it will now be heard through the Party Speaker. Adjust the volume on the
connected device and/or your Party Speaker.
2. You can use the controls on your paired Bluetooth device as well as the volume
control on your Party Speaker.
Controls available on your Party speaker:
Short press to Play/Pause
Short press to skip forward
Short press to skip back
Repeat Short press to repeat the current track or repeat all.
Note: The Repeat function is only available when you are playing music from a
USB stick.