20
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Using your Party Speaker
Using your Party Speaker
Let’s get started
FM radio
If you are not already in FM radio mode, short press the Power/M button to go to FM
mode. Check the display, there will be an FM icon and frequency displayed in FM mode.
Tuning to an FM station
Long press the NEXT button to scan up the FM frequency band.
Long press the PREV button to scan down the FM frequency band.
Your Party speaker will stop when it receives a strong station signal.
FM radio presets
Your Party speaker will automatically store the stations found to its preset locations. Short
press the Next or Prev button to move through the preset locations, stop when
the preset location you would like is displayed.
Aux in mode
If you are not already in Aux in mode, short press the Power/M button to go to Aux in
mode. Check the display.
1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or
auxiliary out) socket of your secondary device. Connect the other end to the Aux in
socket on the top of your Party Speaker.
2. Press the Play button on your external device to start playback through the Party
Speaker.
3. To gain optimal volume levels, adjust the volume level on both the secondary device
and on the Party Speaker.
Note: After you have finished listening to your external device we recommend that you
unplug the audio cable from the Aux in socket
This page is left intentionally blank
To Next Page
Loading...
