Pull out the power plug to avoid electrical shock
before washing.
After using the washer-dryer, remove all the
clothes and close the door tightly.
Remove foreign matters
Drain Pump Filter:
Drain pump filter can filter the yarns and small
foreign matters from the washings.
Clean the filter periodically to ensure the normal
operation of washer-dryer.
According to the soil level within the cycles and
the frequency of the cycles, you have to inspect
and clean the filter regularly.
The pump should be inspected if the machine
does not empty and/or spin; The machine makes
an unusual noise during draining due to objects
such as safety pins, coins etc. blocking the pump.
When the appliance is in use and depending
on the programme selected there can be hot
water
in the pump. Never remove the filter
during a wash cycle, always wait until the
appliance has finished the cycle, and is empty.
When replacing the filter, ensure it Is securely
retight end so.
Warning!
2.Turn the filter
down as shown with
the figure and take
out sundries matters
.(Fig 19)
1.After the power is
disconnected, use
hand to open the
filter cover (Fig 18).
3.Reinstall each part
after sundries
matters are removed
.(Fig 20)
31
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
Care and maintenance
Looking after your appliance
Care and maintenance
Clean the pump filter :
Fig 18
Fig 19
Fig 20
Notes: Generally, the tap filter is washed first
and then the filter in washer-dryer will be
washed.
(Fig16, 17)
If only the filter in is washed, washer-dryer
then the steps 1~3 in cleaning the tap filter
shall be repeated .
Fig 16 Fig 17
4.Clean the filter periodically every 3 months
to ensure the normal operation of the appliance.
4.Open the tap and make sure
there is no water leakage.
5.Close the tap.
6.Clean the Inlet filter every 3 months to ensure
the normal operation of the appliance.
To Next Page
Loading...
