Care and maintenance
Looking after your appliance
30
Before your maintenance starts, please do
pull out the power plug or disconnect power
and close the tap.
- Do not use solvents clean to avoid that the
washer-dryer, it will damage, and toxic
gases are generated or exploded.
- Do not use the detergents containing PCMX
to clean the .washer-dryer
Cleaning and Maintenance of Washer-dryer
Cabinet
- Proper maintenance on the washer-dryer
can extend its working life. The surface can
be cleaned with diluted nonabrasive neutral
detergents when necessary. If there is any
water overflow, use a wet cloth to wipe it
off immediately.
- No sharp items are allowed to strike the
cabinet.
Notes: Do not use formic acid and its diluted
solvents or equivalent .
Clean Internal Drum
- Rust left inside the drum by metal
articles shall be removed immediately with
chlorine-free detergents.
- Never use steel wool.
Defrost a Frozen Washing Machine
When the temperature drops below zero and
your gets frozen, you may:washer-dryer
1.Disconnect the power supply for the
washer-dryer.
2.Wash the tap with warm water to loosen inlet
pipe.
3.Take down inlet pipe and immerse it in warm
water.
4.Pour warm water into washing drum and wait
for 10 minutes.
5.Reconnect inlet pipe to the tap and check
whether inlet and outlet are working normally.
Notes: when the washer-dryer is reused,
make sure the ambient temperature is above 0 C
Anti-freeze
If your is located in the room washer-dryer
where it can get frozen easily, please drain the
remaining water inside drain pipe and inlet pipe
thoroughly.
Clean detergent drawer and
grooves
1.Press down the arrow
location on softener cover
inside the drawer.
2.Lift the clip up and take out
softener cover and wash all
grooves with water.
3.Restore the softener cover
and push the drawer into
position.
Clean inlet filter
Inlet filter shall must be
cleaned if there is
insufficient water when
the tap is opened.
Clean the tap filter:
1.Close the tap.
2.Select any procedure except
“Wash” or “Drain” procedure.
3.Press the button “Start/Pause”
and keep the procedure
running for about 40 seconds.
4.Remove the inlet pipe from
the tap.
5.Use water to wash the filter.
6.Reconnect the inlet pipe.
Washing the filter in washing
machine:
1.Screw off the inlet pipe from
the backside of the machine.
2.Pull out the filter with long
nose pliers and reinstall it back
after being washed.
3.Reconnect the inlet pipe.
Care and maintenance
Fig 11
Fig 13
Remove the remaining water
in inlet pipe:
1.Close the tap.
2.Screw off the inlet pipe from
tap and put its end into a
container.
3.Start up any procedure
except single Wash or Drain
procedure. Water will be
drained out of inlet pipe if any
for about 40 seconds.
4.Reconnect the inlet pipe to tap.
Remove the remaining water in
drain pump (Fig11).
o
Fig 12
Fig 14
Fig 15
Clean the detergent dispenser
every 3 months to ensure the
normal operation of the appliance
To Next Page
Loading...
