Special note for Eco design
1) Maximum amount of dry textiles that can be treated in the respective cyle
2) The highest temperature reached by the laundry in the wash cycle for at least 5
minutes.
3) Residual moisture after the wash cycle in water content percent and the spin
speed at which this was achieved.
4) The ECO 40-60 programme is able to clean normally soiled cotton laundry
declared to be washable at 40°C or 60°C, together in the same cycle. This
programme is used to assess the compliance with the regulation (EU) 2019/2023.
5) The Wash and Dry programme, dry level setting “ ” Extra Dry is able to clean
normally soiled cotton laundry declared to be washable at 40°C or 60°C, together
in the same cycle, and to dry it in such a way that it can be immediately stored in a
cupboard. This programme is used to assess the compliance with the regulation
(EU) 2019/2023.
The most efficient programmes in terms of energy consumption are generally those
that perform at lower temperatures and longer duration.
Loading the household washer-dryer up to the capacity indicated for the respective
programmes will contribute to energy and water savings.
Noise and remaining moisture content are influenced by the spinning speed: the
higher the spinning speed in the spinning phase, the higher the noise and the lower
the remaining moisture content.
Caution!If there is any break in the power supply while the machine is operating, a
special memory stores the selected programme. The machine will continue the
programme when the power supply is re-established.
Care and maintenance
36
Care and maintenance
The model information can be retrieved using the QR-Code reported in the energy label.
The label also includes the model identifier that can be used to consult the portal of the
registry at https://eprel.ec.europa.eu.
1. The higher the spinning speed in the spinning phase, the higher the noise and the
lower the remaining moisture content.
2. The guarantee will be rendered invalid if the product has been damaged by
inexpert repair.
To Next Page
Loading...
