Bush WMSAA714EW/EB - Replacement of Door Hinge; Door Handle

9
Replacement of Door Hinge /
Handle / Seal / Lock
Applicable models
EN
General
Replacement of the door Hinge / Handle
1) Remove all the door nuts.
2) Take apart the outer door / inner door /
hinge / glass / handle.
3) Install a new hinge or handle in reverse
procedures.
Replacement of the door gasket
1) Remove the outer gasket clamp
between the door seal and the front
plate. Loosen the inner gasket clamp
between the door seal and the front of
the outer tub.
2) Install a new gasket in reverse
procedures.
Replacement of the door lock
1) Remove two screws on the door lock
and take down the door lock.
2) Take out the door lock and draw out the
plug.
3) Install a new lock in reverse procedures.