Support: (800) 398-4416,ext. 2
Mon - Fri: 6am - 10pm E
Sat - Sun: 8am - 8pm ET
Email: support@butterflymx.com
This part serves as a marker for drilling the passage of the cables in the cable gland. It
can be removed by bending or turning it on itself or by cutting it at the base.
6. Put the reader back on the mounting plate by
sliding it down on the 4 mounting screws.
7. Tighten the locking screw (with its gasket) with
the provided Torx T8 tool.
4
Mounting Instructions
Place and mount the metal mounting plate onto
the wall. Use the mounting plate as a drilling
template.
4. Place and mount the metal mounting plat 5. Pass the wires through the reader cable gland.
Adjust the emergent cable length to allow normal
closing of the reader
To Next Page
Loading...