Need help?Do you have a question about the BWT FI Series and is the answer not in the manual?
Highlights critical instructions for user safety using a specific symbol.
Specifies that the appliance is not for unsupervised use by persons with reduced capabilities.
Details handling risks during delivery, intended use, and adherence to instructions.
Guidelines for packing and storing the appliance to prevent damage and maintain warranty.
Details the CE standard conformity and relevant safety regulations for BWT pool heat pumps.
Highlights potential dangers such as electrically controlled parts and moving parts.
Informs about the HP pressure controller setting on BWT heat pumps.
Specifies operating temperature ranges and conditions for optimal heat pump performance.
Requirements for installing the heat pump, including location and clearances.
Guidance on selecting a suitable outdoor location for the heat pump installation.
Tips for optimizing installation, such as airflow management and vibration isolation.
Details on connecting the heat pump to the pool filtration circuit via a by-pass.
Diagram and explanation of the power supply connector terminals and wiring.
Instructions for connecting the filtration pump to the heat pump for heating priority control.
Guidance on checking the setting for heating priority parameter #9.
Steps for connecting the heat pump to the pool water circuit and initial startup procedures.
Explains the normal display when the heat pump is in heating mode.
Overview of all icons that can be displayed on the digital controller.
Identifies the function of the buttons located below the display.
Details how to switch the machine ON/OFF via the controller.
Describes how to change and select different operating modes (Smart, Eco, Boost).
Instructions on how to set the time on the digital controller.
Procedure for setting the desired water temperature using the controller.
Explanation of symbols indicating water flow, fan, compressor, and defrost status.
Explains how the heat pump detects water flow and the meaning of the 'flow' LED.
Information on accessing and checking internal parameters, recommended for professionals.
A table detailing error codes (Screen, Explanation, Check, Solution).
Instructions for downloading the app and connecting the heat pump via Wi-Fi.
Steps for downloading the 'Smart Life' app, creating an account, and pairing the heat pump.
Press the Wi-Fi module button for 5 seconds to start the pairing process.
Enter network name and password in the app, then confirm.
Wait for the countdown and confirmation that the heat pump is connected.
Adjusting water flow via the by-pass valve for optimal heat pump performance.
Specifies the ideal water flow rate for maximum heat transfer.
Troubleshooting abnormal pressure by adjusting water flow with the by-pass.
When and how often to check and adjust water flow settings.
Procedure for winterizing the pool system and protecting the heat pump.
Specifies recommended chlorine concentration and pH levels for water quality.
Steps for restarting the swimming pool and heat pump at the beginning of the season.
Guidance on reducing filtration period and maintaining pool temperature.
List of checks to be performed on a monthly basis for maintenance.
List of checks to be performed on a yearly basis for maintenance.
Information required for technical support and troubleshooting.
To Next Page
General
