BWT SP601 - Pump Operating Modes; Underwater Light Operation; Underwater Light Mode Selection; Filtration Cycle Management

The user has no control over operation of the heater. In auto mode or low-speed manual mode, if a heating
demand is detected (water temperature below the setpoint), the heater is started and can only be stopped
by stopping the pump, switching to high speed mode or lowering the setpoint temperature.
4. OPERATION OF THE UNDERWATER LIGHT
THE SPA IS FITTED WITH AN LED THAT HAS 13 COLOUR
SETTINGS AND 3 OPERATING MODES.
Press the 'up arrow/ light' key repeatedly to cycle through the following operating modes :
HEAT
PUMP
AUTO
AIR
UW Light continuously lit white
UW Light continuously lit: colour may be selected
Slow cycle through 12 colours (colour change every minute)
Rapid cycle through 12 colours (colour change every 5 seconds)
Light o󰀨
Scroll through the colour
selection by pressing the "up
arrow" key repeatedly. The last
colour displayed will be saved
to memory for this mode.
A luminous point on the bottom right of the temperature display lights up when the underwater light is on.
The underwater light switches o󰀨 automatically after 30 minutes.
5. FILTRATION CYCLE
The spa launches a ltration cycle once an hour to remove particles and other suspended matter, the user
may set the length of the ltration cycle between 0 and 15 minutes (that is a cumulative total of between 0
and 6 hours ltration per day.)
If the pump runs between programmed ltration cycles in order to heat the spa, the system will determine
whether or not it is still necessary to launch a ltration cycle, and the length of said cycle, based on the
length of the ltration cycle set by the user so that ltration requirements are met.
Setting the length of the ltration cycle:
Press the
HEAT
PUMP
AUTO
AIR
and "AIR" keys simultaneously to display the length of the ltration cycle currently stored
in memory. (the default value is 10 minutes). Press the arrow keys to increase
HEAT
PUMP
AUTO
AIR
or decrease
HEAT
PUMP
AUTO
AIR
the length of the ltration cycle.
NOTA BENE: The user can launch a 90 minute ltration cycle immediately after a session by selecting the
manual low speed mode (see paragraph 3).
12/16
2020/10 - Indice de révision : A - Code : 37833 SPAS