BWT SP601 - Blower Operation; Blower Operating Modes; Regulating Blower Speed; Ozonator Operation

6. BLOWER OPERATION
(
THIS OPTION IS AVAILABLE FOR
SOME SPA MODELS
)
6.1 the various modes
Use the "AIR" key to start and stop the blower and to select the operating mode:
1st Press – start up at full speed (red LED)
2nd Press – speed regulation mode (orange LED)
3rd Press – oscillation mode (green LED)
4th Press – blower stopped (LED out)
Note: The blower stops automatically after 20 minutes of operation.
6.2 regulating the speed (orange LED)
In this mode, the blower speed can be adjusted using the up and down arrow keys.
HEAT
PUMP
AUTO
AIR
HEAT
PUMP
AUTO
AIR
Note: while the blower is running in full speed mode or oscillation mode, pressing one of these keys will
switch the device to speed regulation mode.
Step 1 : press the " AIR " key twice to access speed regulation mode. The LED lights up orange.
Step 2 : press the
HEAT
PUMP
AUTO
AIR
key to increase the blower speed.
Step 3 : press the
HEAT
PUMP
AUTO
AIR
key to decrease the blower speed.
7. OZONATOR OPERATION
(
SOME SPA MODELS ARE
FITTED WITH OZONATORS
)
The ozonator starts up when the spa is energised. It stops automatically in the following two cases:
• The pump is running at high speed
• The blower is running
8. ERROR CODES FOR TROUBLE SHOOTING
For some system malfunctions, the control panel carries out a self-diagnosis and displays a corresponding
error:
NOTA BENE :
to reset after an error, press the
HEAT
PUMP
AUTO
AIR
HEAT
PUMP
AUTO
AIR
and "PUMP" keys simultaneously, (cutting
and reestablishing the electrical supply to the spa will not unlock the system).
However, the spa may switch back to error if the cause has not been remedied.
13/16
2020/10 - Indice de révision : A - Code : 37833SPAS