BYD F0 - Page 51

BYD AUTO F0 Owner’s Manual
48
Notice
 Shining of the light during
engine operation indicates faults of
the charging system or break of the
engine belt. Please drive the vehicle
away from the road and park it in a
safety place and then immediately
stop the engine. Inform a BYD
authorized service station for help.
(d) Low engine oil pressure indicator
The light is used for indicating that the
engine oil pressure is too low.
In driving, if the light flashes or keeps
shining, drive away from the lane and park
the vehicle in a safety place and then
immediately stop the engine. Ask a BYD
authorized service station for help.
The light may flash occasionally when the
engine is idling or shine temporarily after
emergency braking.
However, if it goes out when the engine
accelerates gradually, the problem may be
neglected.
When the engine oil level is very low, the
light can also shine. This light is not used
for showing low engine oil levels; the
engine oil level should be determined with
an oil measuring tape.
Notice
 Do not drive the vehicle—even
for a short distance—when the
indicator is shining; otherwise, the
engine may be damaged.
(e) Engine fault indicator
The light will shine if the electronic fuel
injection system of engine has faults or the
pollutant emission has exceeded the control
standard.
If the light turns on in driving, inform a
BYD authorized service station to examine
the vehicle as soon as possible.
(f) Door-open warning light
Whatever position the key is in, the warning
light will shine as long as there is a door
open.
(g) Low fuel level warning light
The light will shine if the fuel in the fuel
tank nearly runs out. Add plenty of fuel as
soon as possible.
When the vehicle is climbing a steep slope
or turning, the low fuel level warning light
may shine earlier than usual due to shake of
the fuel in the fuel tank.
(h) “ABS” warning light (optional)
When the ignition key is turned to position
“II”, the warning light will shine. If the
ABS system works normally, the warning
light will go out after a few seconds. If the
system has faults, the warning light will
shine again.
When the “ABS” warning light is shining
(the brake system warning light is out), the
ABS system won’t work, but the brake
system can still work normally.
When the “ABS” warning light is shining
(the brake system warning light is out), the
ABS system won’t work, so in emergency
braking or braking on slippery roads, the
wheels will be locked.