BYD F0 - Replace bulb

BYD AUTO F0 Owner’s Manual
125
Notice
 Don’t use engine antifreeze or
other substitutes, because this will
damage the vehicle paint.
Replace bulb
The following figure shows the method to
take out the bulb. When replacing the bulb,
please make sure that the ignition switch
and light switch have been closed. Please
use bulbs with the same rating power as
the following table shows.
Friendly Tips
z When the bulb is hot, please
don’t replace it to avoid burning.
z The halogen bulb is filled with
pressurized gas, you should be
particularly careful. If the bulb is
scratched or falls to ground, it may
explode or crack. You should hold the
plastic or metal part of bulb. Don’t
touch the glass part of bulb with bare
hands.
Notice
 You should use the bulbs as
shown in the following table.
When traveling in rain or when the light
shade is wet after washing, the inside of
lamp shade of external light such as
headlight will temporarily fog. As the
windshield fogging in rainy days, this fog
isn’t a trouble as it is due to the
temperature difference between the inside
and the outside of light shade. But if there
is water droplet or water pool in the
lightshade, please contact the service store
authorized by BYD.
Low beam light
1. Open the engine hood, Unplug the
headlight connector.
Bulbs W(watt) Model
Headlight (low
beam)
55 H1
Headlight (high
beam)
55 H1
Front fog light 55 H11
Front parking
light
5 W5W
Front turn signal
light
21 PY21W
Side turn signal
light
5 WY5W
Rear turn signal
light
21 PY21W
Backup light 21 P21W
Rear fog light 21 PR21W
High brake light 5*4 W5W
License light 5 W5W
Reading light 5 W5W
Brake light/ rear
parking light
21/5 P21/5W