3. Rotate the light seat anticlockwise
manually and pull it outwards to
remove the light seat.
4. Rotate the bulb anticlockwise and
pull it outwards to remove the bulb.
The steps of installation is opposite to
disassembly.
Rear combination lamp
The steps of replacing rear turn signal
light and rear fog light is the same as
backup light.
The steps of installation is opposite to
disassembly.
High Mount brake light
1. Rotate the light seat anticlockwise
manually and pull it outwards from the
hole of rear shelf.
2.Pull off the bulb from light seat,
replace the bulb. If it is not convenient,
pull out the connector.
To Next Page
Loading...
