C-LOGIC 8900 Instruction Manual

-20°C~0°C/-4°F~32°F
3.2.6 Temperature Test
1°C/1°F
3.2.5 Circuit Continuity Test
40.00nF
400.0nF
4.000μF
40.00μF
400.0μF
4.000mF
Accuracy
Resolution
Measuring range
0.1Ω
If the resistance of circuit to
be measured is less than
40Ω, the meter ’s built-in
buzzer may sound.
- Overload protection: 600V DC or AC (RMS)
Accuracy
Resolution
Measuring range
±( % reading + digits)3.0 5
±( % reading + digits)1.5 5
- Overload protection: 600V DC or AC (RMS)
- The parameter does not contain thermocouple errors
3.2.7 Capacitance
Accuracy
Resolution
Measuring range
±( % reading + digits)3.0 8
- Overload protection: 600V DC or AC (RMS)
- The parameter does not contain errors caused by base
capacitance and capacitance probe
3.2.8 Diode Test
Function
Resolution
Measuring range
0.01nF
0.1nF
0.001μF
0.01μF
0.1μF
0.001mF
0.001V
Display approximate diode
forward voltage value
- Forward DC current is about 1mA
- Backward DC voltage is about 3.2V
- Overload protection: 600V DC or AC (RMS)
4.3 Maximum/Minimum Measurement Fuction
1) Press “MAX/MIN” key to enter MAX mode, the meter
will enter maximum measurement value; press
“MAX/MIN” key again, the meter will enter minimum
value measurement state; press “MAX/MIN” key
to repeat the above operations by recycling.
2) If the user presses “MAX/MIN” key more than 2 sec,
the meter will restore normal measuring rang
e.
4. Operating Guidance
4.1 Reading Hold Fuction
In the process of measurement, if reading hold is
required, press “LPF/HOLD” key, the value on the
display will be locked. press “LPF/HOLD” key again
to cancel reading hold state.
40.00mF 0.01mF
-0°C~400°C/32°F~752°F
±( % reading + digits)3.0 5
400°C~1000°C/752°F~1832°F
4.2 50Hz/60Hz Current Selection Fuction
In the process of current mode, press “LPF/HOLD” key
more than 2 sec, the meter will enter the LPF(50Hz/60Hz)
current measurement.
35 36
Leakage Clamp Meter Leakage Clamp Meter

C-LOGIC 8900 Specifications

General

Brand	C-LOGIC
Model	8900
Category	Measuring Instruments
Language	English