What to do if C.T.M. HS-850 won’t move when the key is turned on?
If your C.T.M. Scooter doesn't move when you turn the key, try these steps: * First, ensure the power is on. * Second, switch the scooter to the 'D' (drive) position, then turn the power off and on again. * Third, unplug the charger power cord. * If the battery gauge shows less than 25%, recharge the battery and test again.
What to do if C.T.M. HS-850 Scooter displays Error Code 6 - Drive inhibit?
If your C.T.M. Scooter shows Error Code 6, it indicates a drive inhibit. This may be due to an active stop function, charger inhibits, or an OONAPU condition. Try the following: 1. Release any active stop condition, such as a raised seat. 2. Disconnect the battery charger. 3. Ensure the throttle is in Neutral when turning the controller on.
What to do if C.T.M. HS-850 displays Error Code 2 - Low battery fault?
If your C.T.M. Scooter displays Error Code 2, indicating a low battery fault, try these solutions: * First, recharge the batteries. * Second, check the battery and all associated connections and wiring for any issues.
What to do if C.T.M. Scooter displays Error Code 4 - Current limit time-out or controller overheat?
If your C.T.M. Scooter shows Error Code 4, which means the current limit has timed out or the controller is overheating, it might be because the motor has been exceeding its maximum current rating for too long. To fix this: * Turn the controller off, wait a few minutes, and then turn it back on. Also, check the motor and its connections and wiring.
What to do if C.T.M. HS-850 Scooter displays Error Code 1 - Battery low?
If your C.T.M. Scooter displays Error Code 1, which indicates a low battery, the solution is to recharge the batteries.
What to do if C.T.M. Scooter displays Error Code 5 - Park brake?
If your C.T.M. Scooter displays Error Code 5, related to the park brake, it could be due to an active park brake release switch or a faulty park brake. You should: * Check the park brake and its associated connections and wiring. * Also, make sure any related switches are in their correct positions.
What to do if C.T.M. Scooter displays Error Code 3 - High battery fault?
If your C.T.M. Scooter displays Error Code 3, indicating a high battery fault, it could be due to the battery voltage being too high, possibly from overcharging or traveling down a long slope. If you're going downhill, reduce your speed to minimize regenerative charging.
Why doesn’t the light on my C.T.M. HS-850 Scooter charger turn green during charging?
If the light on your C.T.M. Scooter charger doesn’t turn green during charging, check that the input voltage (115V/230V) matches your setting. Also, the battery charger may be defective and require repair.
What to do if ORANGE light on C.T.M. HS-850 charger turns to GREEN immediately?
If the ORANGE light on your C.T.M. Scooter charger immediately turns to GREEN, check if the battery is fully charged. If it's not, the battery may be defective and need to be checked and recovered.
What to do if LED (CHARGE) light is off on C.T.M. HS-850 Scooter charger?
If the LED (CHARGE) light is off on your C.T.M. Scooter charger, ensure the clip connections are correct. If the battery is fully charged, the LED (CHARGE) light will be off. The battery may also be defective.
Details components like the Speed Dial Knob and Battery Gauge on the scooter's top control panel.
Describes the Thumb Lever functionality for scooter movement control and acceleration.
Explains Tiller Angle Adjustment, Seat Height, Armrest Width, and Legroom Adjusters for user comfort.
Details Rear Compartment Cover, Anti-tip wheels, and the Free-Wheeling Lever.
To Next Page
General
