Why does my C.T.M. Scooter battery need recharging?
Your C.T.M. Scooter battery needs recharging because the battery charge is running low or the battery charge is empty. Recharge the batteries as soon as possible.
What to do if my C.T.M. Scooter has a current limit time-out?
If your C.T.M. Scooter has a current limit time-out, it means the scooter has drawn too much current for too long, possibly because the motor has been over-worked, jammed, or stalled. Turn the scooter power off, leave it for a few minutes, and then turn the power back on again.
What to do if my C.T.M. HS-575 Scooter throttle is not in neutral position?
If your C.T.M. Scooter throttle is not in the neutral position, it may need to be recalibrated. Return the throttle to neutral, turn the power off, and then back on again.
What to do if my C.T.M. Scooter will not move when the key is turned on?
If your C.T.M. Scooter will not move when the key is turned on, check the battery gauge on the control panel to ensure all the LED lights are on. Also, check the Self-Diagnostic Warning Light to make sure it is steady. Check all electrical connections to be sure they are tight.
What does it mean if my C.T.M. HS-575 Scooter displays 'Battery voltage too high'?
If your C.T.M. Scooter displays 'Battery voltage too high', it means a charger is plugged in. Unplug it or turn the Charge/Run switch to Run.
What to do if my C.T.M. Scooter displays 'Speed Pot error'?
If your C.T.M. Scooter displays 'Speed Pot error', it means the throttle or its wiring is faulty. Check for open or short circuits. The throttle may not be correctly set up.
What causes a brake fault in my C.T.M. HS-575 Scooter?
A brake fault in your C.T.M. Scooter indicates that the park-brake coil or wiring is faulty. Check the park brake and wiring for open or short circuits.
What to do if my C.T.M. Scooter displays 'Motor volts error'?
If your C.T.M. Scooter displays 'Motor volts error', it indicates that the motor or its wiring is faulty. Check for open or short circuits.
Lists safety warnings regarding EMI for powered wheelchairs and scooters.
Details the function of the speed control knob, self-diagnostic lights, and battery gauge.
Provides troubleshooting steps for common charger issues based on LED status.
Addresses issues like the scooter not moving and charger light not changing.
To Next Page
General
